X-ray Source Operation
Make sure water cooling is ON. There are two separate water cooling lines (each having one inlet and one outlet pipes): one for the anode where the direction of water flow is important, and another for the outer jacket. Set the x-ray gun closer to the sample (linear drive position = 4 cm). Once the measurement is done, retract the gun to linear drive position = 2 cm.
X-rays energies:
Al Kɑ = 1486.6 eV
Mg Kɑ = 1253.6 eV.
Chose the desired anode. For both of them, set:
Anode voltage = 12 kV
Anode current = 10 mA.